Appendix B - 7 - DX Fleet Option
F M S P a r t N u m b e r 2 0 - 7 0 9 2
Applicable Warnings, Battery Safety and Replacement
READ CAREFULLY:
Read all of this section fully before you replace or discard the coin cell
battery used in this device. It is mandatory to correctly understand all warnings and
instructions to prevent dangerous conditions.
The Vantron/Edge board contains a CR-2450 3.0 V Lithium battery.
IMPORTANT:
Read the warning statements below carefully. Make sure you understand and
obey these warnings
DANGER:
The coin cell battery can explode if it is used incorrectly. Do not
recharge, disassemble or discard this battery in fire. Replace the coin cell
battery with Panasonic or Matsushita Electric Part Number CR-2450 or
equivalent ONLY. There can be a risk of fire or explosion if an incorrect battery
is used.
To avoid possible explosion or fire, do not replace the lithium battery with a
type that is not compatible.
The battery used in this device can present a risk of fire or chemical burn if
used incorrectly. Do not disassemble, heat above 100°C or incinerate.
Discard a used, replaced battery immediately. Keep away from children. Do
not disassemble and do not discard in fire.
The inside of the terminal contains high-voltage circuitry; ONLY certified
technicians should be permitted access to the console.
INFORMATION:
For more safety information on the Panasonic CR-2450 coin cell Lithium
battery used in this device, refer to the
Panasonic Product Safety Data Sheet
Doc. No.: M1010 Rev.: 10
Page 73 of 98
Summary of Contents for Petro Vend 200 M1010
