Appendix A - Pair the 20-6020-EXT
Work Instructions to configure and pair the 20-6020-EXT Ethernet Radio Modems
NOTE:
The Access Point and Subscriber units included in the 20-6020-EXT have been
paired at the factory. If it ever becomes necessary to pair the units because of lost
communication (they have lost their pairing) or for a replacement unit, use the procedure
below on how to correctly pair the units.
IMPORTANT:
Do not apply power to either the Access Point or the Subscriber unit until
instructed to do so. Refer to the instructions below.
1. Refer to the image
"Pair the 20-6020-EXT Modems" on page 17
for connections and the steps shown
below.
2. Use a 3mm Allen wrench (not supplied) to remove the cover from one of the units. This unit will be
specified as the
Access Point
.
3. Make sure the Access Point and the Subscriber Unit are set at least
10 feet
apart.
4. Attach the
antennas
to both units.
5. Connect a
12-3003 Ethernet cable
from each radio modem to the female connector of its PoE cable.
NOTE:
To correctly pair the two (2) Ethernet radio units of the 20-6020-EXT, it will be
necessary to have an RJ45 coupler. This is NOT a supplied component.
6. Use an
RJ45 coupler
(NOT supplied) to connect the RJ45 ends of both PoE cables together.
7. Connect the two power supply cords to their PoE cables.
Do not plug the power supplies into power
outlets at this time
.
8. Turn switch "1" of the specified Access Point unit to the
ON
position (Switch 1 is toward the side of the
board of the antenna coaxial connector).
9. Plug in the power supplies of both units to power outlets to turn the units on.
10. The
link quality LEDs
on both units will sequence up and down for 5 seconds (The LEDs of the
Subscriber Unit can be seen through the LED view window on the cover of the unit).
Doc. No.: M00-20-6020 Rev.: 1
Page 15 of 22