OPW M00-051.00 FSC3000, Command-Line Configuration Manual

Page: 40 / 181

If using K800™ PCT or PCM (Mechanical), up to four (4) positions maximum are supported.
Type:
Configure PCT # (K800 PCT and PCM addressable from 1 to 8)
Is this a K800 PCT or PCM (Y/N)? Y
6.1.2 Configure PCT # POS # (PCT 1 to 8 and POS 1 to 8)
The
Configure PCT # POS #
command configures each fueling point that is connected to the specific
PCT. Each fueling point is to be wired to a specific position on the pump interface.
Type:
Configure PCT # POS # <ENTER>
PCT 1 Position 1 (Indicates what position is being configured)
Enter Pump #: 1 (Enter the pump # that is connected to this PCT POSITION)
Enter Pulses Per GALLONS: 100 (Enter the pulse rate for the pump)
MAX Fuel to be dispensed per transaction: 10 (Largest tank to be filled for this
pump)
Pump Sentry Options (Y/N)? Y (Protects against pulser\wire failure)
Pump Sentry: ENABLED
Maximum time allowed for fueling (Minutes): 5
Maximum time allowed to retrieve pump handle (Seconds): 60
Maximum time allowed to detect first fueling pulse (Secs): 60
Maximum time allowed between fueling pulses (Secs): 30
Enter Fueltype Code #: 1 (Enter the fuel type code for the product that will be
dispensed)
Enter Tank #: 1 (Enter Tank number – not required for proper operation)
Clear Pump Totals (Y/N)? N
Enter Totalizer Value: 0.0 (Should set to match fueling point mechanical totalizer)
Repeat process to configure each position that is wired to a fueling point.
6.1.3 Install PCT # POS # (PCT 1 to 8 and POS 1 to 8)
The
Install PCT # POS #
command tells the system that a PCT position will be used.
Repeat process to install each configured position.
6.1.4 Install PCT # (# = 1 to 8)
The
Install PCT #
command tells the system that the PCT is there and it should communicate with it.
Doc. No.: M00-051.00 Rev.: 10
Page 40 of 181