OPW Installation, Operation and Maintenance Manual, Page 6 Executive Order VR-401-C
1DK-2100 EVR Replacement Drain Valve Performance Specifications:
This Spill Container drain valve has been
manufactured and tested to the following California
specifications: Leak Rate to be less than or equal to
0.17 CFH @ 2.0" W.C.
Operation and Maintenance:
To open, pull drain valve chain up and hold open
until liquid is drained. To close, release chain.
Annually:
Inspect and clean the interior of the spill container
and drain valve screen. Remove accumulated dirt
and grit. Test the drain valve using CARB
procedure TP-201.1C or TP-201.1D. If the drain
valve passes testing no further maintenance is
required. If the drain valve fails testing, remove the
valve, soak in water and use high-pressure air, if
needed, to clean. Reinstall the drain valve to its
proper position and test the valve with CARB
procedure TP-201.1C or TP-201.1D.
Important:
Leave these instructions with the
Station Operator.
NOTICE:
OPW products must be used in compliance with
applicable federal, state, and local laws and
regulations. Product selection should be based on
physical specifications and limitations and
compatibility with the environment and material to be
handled. OPW makes no warranty of fitness for a
particular use. All illustrations and specifications in
this literature are based on the latest production
information available at the time of publication.
Prices, materials, and specification are subject to
change at any time, and models may be
discontinued at any time, in either case, without
notice or obligation.
Standard Product Warranty
OPW warrants that products sold by it are free
from defects in materials and workmanship for a
period of one year from the date of manufacture by
OPW (ECO products two years from date of
manufacture.) Proof of purchase may be required.
As the exclusive remedy under this limited warranty,
OPW will, at its sole discretion, repair, replace, or
issue credit for future orders for any product that
may prove defective within the one-year date of
manufacture period (repairs, replacements, or
credits may be subject to prorated warranty for
remainder of the original warranty period, complete
proper warranty claim documentation required.)
This warranty shall not apply to any product that has
been altered in any way, which has been repaired by
any party other than a service representative
authorized by OPW, or when failure is due to
misuse, or improper installation or maintenance.
OPW shall have no liability whatsoever for special,
incidental or consequential damages to any party,
and shall have no liability for the cost of labor,
freight, excavation, cleanup, downtime, removal,
reinstallation, loss of profit, or any other cost or
charges.
For any product certified to California 2001
standards, OPW warrants that products sold by it
are free from defects in material and workmanship
for a period of one year from date of manufacture or
one year from date of registration of installation not
to exceed 15 months from date of manufacture by
OPW.
THIS WARRANTY IS IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED, AND
SPECIFICALLY THE WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE. THERE ARE NO
WARRANTIES WHICH EXTEND BEYOND THE
DESCRIPTION ON THE FACE HEREOF.
P.O. Box 405003 * Cincinnati, Ohio 45240-5003
1-800-422-2525 Domestically
513-870-3315 Internationally
www.opw-fc.com
Copyright, 2003– OPW Fueling Components Inc., Cincinnati, OH
Printed in U.S.A. p/n H11471PA – 9/03
