Noise sensor for
COMPACT SYSTEM
NS-CAN
NS-CAN version 3.2.001
8
4.5.
Connection between several NS-CAN
5.
COMMISSIONING THE NS-CAN
Commissioning the NS-CAN requires sending of configurations to the COMPACT audio matrix to whose CAN bus the NS-CAN is
connected. To do this, you need a PC equipped with a network card and connected to the COMPACT matrix, either through a
Ethernet switch, or directly through a network cable. The PC must have the
Call Point
software installed.
1. Set the CAN address of the NS-CAN and its position in the BUS (end or intermediate element).
2. Make the connections between equipment.
3. Apply power to the units.
4. Via the
Call Point
software, configure the parameters of the NS-CAN and adjust the NS-CAN values for each zone.
(Intermediate
bus element)
(Final bus
element)
(Intermediate
bus element)
Figure 9a
CAN Bus
24V DC
Power
supply
(N
ot
co
nne
ct
ed)
(N
ot
co
nne
ct
ed)
Figure 9b
CAN Bus
24V DC
Power
supply
(Intermediate
bus element)
(Final bus
element)
(Intermediate
bus element)
(N
ot
co
nne
ct
ed)
(N
ot
co
nne
ct
ed)
Summary of Contents for NS-CAN
