Instrukcja obsługi niszczarki TS 2222 CD
Operation:
•
The equipment should be placed on a level floor.
•
Before plugging in the equipment, ensure there is nothing in the slots, like paper, cards or
CD/DVDs and that the paper bin is fitted properly, there is a micro switch which if the bin is not
fitted correctly the motor will not start.
•
There are two push buttons on the top marked, FWD, REV, and 1 power switch on the back for on
& off.
•
Before plugging in the equipment, ensure that power switch is on “0” pressed in.
•
To operate, switch the power on. On the top there is a small panel with the symbol
when the
power is turned on the symbol goes blue, ready to work, If the unit is not used the shredder will go
into standby, when you insert paper, DVD/CD or a credit card it will automatically start.
•
FWD it will start the cutting blades going for 10 seconds each time you press the button. It is only
for when you shred very small pieces of paper or clean out some paper that had not gone through
on auto.
•
Insert paper into the feed slot on the top and it will start automatically. NOTE! Paper should be only
put in the middle of the slot.
•
Maximum paper width of 225mm. If the pages are wider, cut or fold to fit the slot. You can only
shred 22 sheets of 80 g/m² paper at a time.
•
If the temperature of the electric motor gets to hot the shredder will automatically turn off and the
symbol
will turn
Red.
•
When the electric motor has cooled down the red light will go off and then motor will be ready to
start again.
•
Shredding credit cards. The shredder shreds only
one
credit card or
one
CD/DVD at a time.
•
It is impossible to shred paper and credit cards or CD/DVDs at the same time.
•
Turn the power switch off when shredding is finished
•
If too many pages of paper are inserted into the slot, it will cause the paper to jam inside the cutting
blades.
•
Pull out the surplus jammed/stuck paper out and press the switch marked REV to (reverse) the
paper out.
•
Press “FWD” (forward) to shred any paper scraps left in the cutting blades.
•
If it will not solve the problem, contact the dealer or the service team.
Cleaning:
•
Before cleaning the shredder ensure that the main power is switched off,
then unplug the equipment from the mains socket.
•
When the shredded paper bin gets overfilled, it may cause problems and paper will go inside the
mechanism feed and there is a risk of fire. Pull the bin out, remove shreds and re-install the bin
under the shredder.
•
To avoid problems please clean the shred bin regularly before it overfills.
•
Cleaning the housing. Wipe the cover of the shredder with gentle home detergent or a damp
piece of cloth.
•
Do not put the equipment into water.
•
Do not wipe the unit with petroleum, thinners, alcohol or solvents. They can cause permanent
damage to the housing and the plastic.
Maintenance:
•
To prevent reduction of efficiency, increased sound levels and to prolong the lifespan of the
equipment, it is necessary to oil cutting blades regularly.
•
After filling the waste bin several times, the blades should be oiled with a special oil (provided by
OPUS).
•
Put a little oil on a few pieces of paper and shred them so that the oil will spread on the whole
cutting mechanism.
