6 MAINTENANCE
-
In process of laminating, bit of adhesion comes out from film and it stains roller.
If let the remnant lays on the rollers, it effects low quality result of laminating and
become a factor of trouble on laminator. Therefore, clean the rollers at regular interval
or ever so often.
- First of all, get rid of Table and Safety Cover. Let the roller rotate and find the spot by
RUN / STOP
or
REVERSE
key. Then scrub with alcohol dipped a cloth.
•
Must not clean while roller runs.
•
Do not use for cleaning such steel wool which may damage the surface of rollers.
•
Do not let roller be pressed for a long to avoid spoiling rollers.
•
Keep the idle roller clean always.
OPUS RolLAM 720 mm • User guide
GB
11
There may occur temporarily temperature changes at the beginning of laminating.
However, it is normal progress to reach set temperature afterwards.
7 TROUBLESHOOTING GUIDE
1. The temperature does not ascend as long time has passed
- Heater may be off.
Turn heater on by using Temperature Control Key.
- Thermostat which is way of prevention overheating is on
Afterwards let the laminator cool, go on operation.
If the problem repeats contact an authorized service representative.
2. Laminator is inoperative
- Main power fuse is down.
Change fuse which has to be the same specification.
If the problem repeats, contact an authorized service representative.
- Fuse on PCB is down.
Contact an authorized service representative.
3. The roller does not rotate
- There is not film left.
Change the film.
- Too much tension of film.
Too much tension cause rather inferior quality. Adjust proper tension.
- The laminator is in operation with an upward roller.
Lift roller down and adjust proper pressure.
4. The temperature is measured very low or overheat
- There is something around infrared temperature sensor that hides sensor.
Caution in handling film to prevent to be clinging in the rollers or hang down.
Make sure that there is no articles between roller and temperature sensor.
