HOT LAMINATION
•
Turn the laminator on. You must press the “HOT” button for 1 second each time you
switch on to set the laminator to the factory setting.
•
Factory settings are temperature - 100˚C and speed 4, these settings are suitable
for laminating 100 μm, microns pouches.
•
The laminator will make 3 short bleeps and show ‘READY’ on the display when
it reach the set temperature.
•
Now you can start laminating.
•
Lamination temperature can be changed by pressing the buttons ( ) for up or ( )
for down by in increments of 1 degree (maximum 160 ˚C).
•
Lamination speed can be changed by pressing the button ( ) for faster or ( )
for slower buttons speed 1 – 9 in increments of 1.
•
If the quality of lamination is not satisfactory, press the REV button until the
document is reversed out, when you release the button after 2 seconds the rollers
start to move forward.
•
Change the lamination settings and insert document once again into the slot.
•
To turn the laminator off, do not turn off by the main switch as the rollers need to
cool down. Press the POWER button. When the temperature decreases to a safe level
the powers will turn off automatically.
COLD Lamination
•
Turn the laminator on. Press the COLD button.
•
Start lamination, when READY is displayed on a screen.
•
To avoid damaging of materials like picture, it is recommended to choose COLD
lamination and use a special pouch.
10
4 LCD DISPLAY
TEMPERATURE ( or )
– Push the proper button to increase or decrease temperature.
The scale is 0˚C
- 160˚C and changes each 1 ˚C.
CARRIER
– Set the equipment to 130˚C speed 3, the default setting for lamination of 80 μm
(E mil). Using a carrier.
MOUNT
– This function can be selected upon laminating hard board types with more than
1mm thickness, and temperature of 150˚C at & speed 1 is automatically set when selected.
˚C/ ˚F
– Change the temperature format.
STAND BY
– This function can be selected when you have a short break not for long periods.
Temp 80˚C and speed 2 is set automatically.
HOT
- When selecting hot function key, laminating temperature is set to 100 ˚C speed
4 is set automatically.
COLD
- Function can be selected for cold laminating, automatically set the temperature 0˚C
speed 2.
SPEED
– This function can be selected ( or ) for increasing or decreasing lamination speed
from 1 - 9 speed.
MEASURE
- This function shows present temperature. The measured is displayed for
3 seconds.
Summary of Contents for ProfiLAM A2
Page 7: ......
