9
Malfunction
Laminating pouch stuck
inside the laminator
Both LEDS are off at the
same time
Possible Cause
Too high laminating temperature
The laminating pouch was
inserted into the opening with
the wrong end
Maximum laminating thickness
exceeded
Main switch is in OFF position
The Power voltage was cut off
because of the equipment over
heating
Remedy
Try reversing the document out
or pull the laminated document
out of the feed opening. If it is
not possible, contact the dealer
or service team. Do not take the
cover out of the laminator!
Check if the equipment is
switched on, if the fuse is working
correctly. If this does not solve
the problem, contact the dealer
or service team.
In case of any other problems switch off the equipment, remove the plug from a socket and contact the
Dealer or service team
.
Technical Data:
Heating system:
2 rollers with Hot shoe heaters
Drive system
2 rollers
Preheating time:
3 - 5 minutes
Recommended pouch thickness:
up to 80 microns / 100 - 125 microns
Max document thickness:
0,7 mm*
Laminating width:
330 mm
Laminating speed:
300 mm / minute
Voltage:
AC voltage 220 - 240 at 50 Hz
Power:
500 W
Rated current:
2,5 amps
Dimensions
W - 480 x D - 150 x H - 85 mm
Net weight:
3,4 kg
* Document with foil
14.08.2012
10.04.2012 KCH © Copyright OPUS PL: Distributor: OPUS Sp. z o.o.
●
Toruńska 8
●
44-122 Gliwice
●
www.opus.pl
User’s guide popLAM A3
