User’s guide OPUS cityLAM A4
8
Operation:
1. Starting the equipment :
• Plug the equipment into the power socket and turn on by pressing the button
• Press the buttons on the touch panel to setup the thickness of pouch required from the range
of foil thicknesses from 80mic – 200mic. The process of heating will start automatically.
• The heating time for the laminator rollers is 4-6 minutes. during this time on LCD display the
red diode.
• When laminator is ready the green diode flashes. The equipment is now ready to use.
2. Preparing the document :
• Choose correct thickness and type of pouch. Put the document into the pouch.
NOTE! It is recommended to leave approx. 3mm margins all around the document
from the edge.
3. Hot lamination
• Open the flap at the back of equipment, insert the laminating pouch from the front with the
document inside it into the rollers, and remember to put the sealed end first.
• The pouch/document will move through the unit and exit at the back.
• If the lamination is not good you can repeat laminating or change settings
• After one hour in “stand by” mode the machine will turn off automatically
4. Cold lamination
• Plug the equipment into the power socket and turn on by pressing the button. Choose proper
option on display for „cold lamination”
• After hot lamination wait 40-60min to cool down the equipment before you start to cold laminate.
Maintenance and service:
• Before clearing the equipment, remove the power plug from the socket.
• If the pouch was entangled into the rollers or the laminator does not operate correctly contact
the dealer or service team
