Opus Atlas 150, User Manual, Page: 4 / 4

Important!
In some cases (e.g. too big channel size comparing with the number
of pages) it may happen that the documentation is not bound properly.
In such case, after lifting the arm (1), move the handle (2) to the right
until you feel the resistance and then repeat step 8.
D De eb biin nd diin ng g
1. Lift the arm (1) maximally up.
2. Move the adjusting handle (2) maximally to the left
3. Place the wedge (5) ,with its narrower edge directed
to the spine, a few millimeters from the back cover
of the document. Back, flat side of the wedge (5)
must face the front cover. Plastic part of the wedge
should be placed in-between the channel incisions.
4. Fit the ends of the wedge (5) in the debinding hooks(4)
Note
Make sure, the back cover of the document
is placed on the top
5. Move the adjusting handle (2) to the right
6. Press the arm (1) firmly down holding the handle (2)
at the same time.
7. Raise the arm (1) up, move the adjusting
handle (2) to the right and press
the arm (1) down again.
Repeat for several times.
8. Lift the arm (1) up, loosen the adjusting
handle (2) and remove the document
together with the wedge (5), then take
the wedge (5) out of the document
carefully.
9. Make the planned changes
to the document.
The cover may be re-used
(a maximum of three times)
Technical data:
Binding capacity ................up to 150 pages*
Net weight ........................................14,64 kg
Dimensions (mm) ........................418/269/65
* the tests were made on 80g/m
2
substance paper
16
13
10
7
MINI
27.09.2004