Installation
Composition and assembly ofthe loop
The loop consists on the following 3 elements: a loop cable, a loop adapter and a connecting
cable.
The loop is ready but it is possible to disas- semble it to adapt it to the reception desk. See
below.
To disassemble the loop that will equip the counter, first unscrew the support of the elec- tronic
card.
Connect the beginning and the end of the loop cable to the circuit board (red connector).
Then plug the 50-70 cm connecting cable sup- plied to the "amplifier" connector of the adap- ter
and to the "Loop" terminal block of the am- plifier.
Your loop is now created and connected.
Installation of the loop in the coun-
ter
1.
Place
the loop on the vertical and
horizontal portion of the counter as shown
in figure 1. This type of installation ensures
better coverage in front of the counter.
Figure1.
Note:
The wire supplied in the DLC20-65 kit ensures the quick installation of a magnetic
loop system in a reception desk, counter or cash desk.
In order to optimize the radiation of the magnetic field and to guarantee a
. better result he wire should be placed close to the customer.
Loop
amplifier
11
There are 3 possibilities to place a loop in a
counter as described below, however we
strongly advise you to use the first version
Summary of Contents for OP-6507/B
Page 1: ...Digital Window Intercom User Guide 2020 OP 6507 B 1 ...
Page 2: ...2 ...
Page 15: ...Notes 15 ...
