-23-
5.1.4
Auxiliary Connector
Auxiliary connector is used to access camera Sync In and Sync Out IOs and for firmware updates.
The connector is labelled “A” for CP80 and “Aux” for CP90.
Camera accessory “Pigtail cable” gives user 2 x 50 ohm BNC connectors to acce
ss Sync IN and Sync Out
signals.
Camera accessory “Programming cable” allows an USB connection to a PC for firmware updates.
CP80 Series
CP90 Series
Connector info:
Camera (A) connector type:
•
LEMO EGG.0B.304CLL
Cable Connector:
•
LEMO FGG.0B.304.CLAD56Z
Connector info:
Camera (Aux.) connector type:
•
Hirose HR10A-7R-6S
Cable Connector:
•
Hirose HR10A-7R-6P
Connector View:
]
Figure 15: CP80 Auxiliary Connector
Connector View:
Figure 16: CP90 Auxiliary Connector
Connector Pinout:
Connector Pinout:
Pin 1: Sync IN
External Synchronization Input.
TTL level:
< 0,8 Volt (low)
> 2 Volt (high)
Pin 1: Sync IN
External Synchronization Input.
TTL level:
< 0,8 Volt (low)
> 2 Volt (high)
Pin 2: Reserved
Pin 2: Reserved
Pin 3: GND
Ground
Pin 3: Sync Out
External Synchronization Output.
TTL level @ high impedance,
0 to 2 Volt @ 50 Ohm.
Pin 4: Sync Out
External Synchronization
Output.
TTL level @ high impedance,
0 to 2 Volt @ 50 Ohm.
Pin 4, 5, 6: GND
Ground
