Optoma ZH510T-B, User Manual

Page: 17 / 50

English 17
SETUP AND INSTALLATION
Powering Off the Projector
1. Press the “ ” button on the remote control or on the control panel to turn off the projector.
The following message will be displayed on the screen.
Press the “ ” button again to confirm otherwise the message will disappear after 10 seconds. When you press
the “ ” button for the second time, the fan will start cooling the system and will shut down.
2. The cooling fans continue to operate for about 4 seconds for cooling cycle and the POWER/STANDBY LED will
flash Red. When the POWER/STANDBY LED lights solid Red, the projector has entered standby mode.
If you wish to turn the projector back on, you must wait until the projector has completed the cooling cycle and
has entered standby mode. Once in standby mode, simply press “ ” button to restart the projector.
3. Disconnect the power cord from the electrical outlet and the projector.
Warning Indicator
LED lightning messages
When the warning indicators (see below) come on, the projector will automatically shutdown:

“LAMP” LED indicator is lit red and/or if “TEMP” LED indicator is lit red.

“TEMP” LED indicator is lit red, this indicates the projector has overheated. Under normal conditions, the projec-
tor can be switched back on.

“TEMP” LED indicator flashes red.
Unplug the power cord from the projector, wait for 30 seconds and try again. If the warning indicator light up again,
please contact your nearest service center for assistance.
Message
Power LED
Temp LED Lamp LED
Red Blue Red Red
Standby State (LAN Off)
On
Standby State (LAN On)
On On
Power On
On
Warning Up
Flashing
Error(PowerGood NG)
On On
Error (Fan fail)
Flashing
Error (Over Temp)
On
Error (LD fail)
On