E
nglish
12
Installation
Powering Off the Projector
1.
Press the “Power” button to turn off the projector lamp,
you will see the following message “Power off the lamp? ”
displayed on the screen.
2.
Press the “Power” button again to confirm. Otherwise the
message will disappear after
5
seconds.
3.
The cooling fans continue to operate for about 120 seconds
for cooling cycle and the Power LED will
turn
red. When
the light
stops flashing
, the projector has entered standby
mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and has
entered standby mode. Once in standby mode, simply
press “Power” button to restart the projector.
4.
Disconnect the power cord from the electrical outlet and
the projector.
5.
Do not turn on the projector immediately following a
power off procedure.
When the “LAMP” indicator lights orange continuously, the lamp
may failed. Please contact your local reseller or service center.
When the “TEMP” indicator flashes orange for about ten seconds,
you will see a message “Fan Fail” or “Over Temperature”on the
display. The projector will automatically shut down. After cooling,
under normal conditions, the projector can be switched on again for
your presentation. If the problem persists, contact your local reseller
or service center.
