English
Replacing the Lamp
The projection lamp should be replaced when it burns out. It should
only be replaced with a certified replacement part, which you can
order from your local dealer.
Important:
4
The lamp contains a certain amount of mercury and should be
disposed of according to local ordinance regulations.
4
Avoid touching the glass surface of the new lamp, doing so
may shorten its operation life.
Warning:
4
Be sure to turn off and unplug the projector at least an hour
before replacing the lamp. Failure to do so could result in a
severe burn.
1. Loosen the two captive screws on the lamp compartment cover
(A)
. Remove the lamp compartment cover
(B)
.
2. Remove the two screws from the lamp module
(A)
. Lift the
module handle up
(B)
.
3. Pull firmly on the module handle to remove the lamp module.
4. 5 & 6. Insertion is the reverse of removal.
After replacing the lamp, the lamp hours counter must be reset.
See page 43 for more information.
B
A
A
B
1
2
3
4
Appendices
Downloaded From projector-manual.com Optoma Manuals
