CHAPTER 2: INSTALLING A SNAP PAC BRAIN
SNAP PAC Brains User’s Guide
7
7
4.
(Optional) As shown in the photo at right,
use standard 4-40 x 1/2 truss-head Phillips
hold-down screws to secure both sides of
each module.
CAUTION:
Do not over-tighten screws.
5.
Plug the wiring connector into each
module to attach modules to the devices
they monitor.
Wiring diagrams are in the module’s data
sheet.
Removing a Module
1.
If the modules are held in place with
screws, remove them.
2.
Holding the SNAP module tool
(provided) as shown in the illustration at
right, insert it into the notch at the base
of the module.
3.
Squeeze the module tool against the
module to open the release latch, and
pull straight up on the module to
remove it.
4.
Continue with
