Optiview NV432P16-4K, User Manual

Page: 37 / 297

104
Name Function
Ground Alarm input ground end.
NO1
～
NO5
Alarm output port 1
～
5

5 groups of alarm output ports. (Group 1
：
port
NO1
～
C1,Group 2:port NO2
～
C2,Group 3:port
NO3
～
C3, Group 4
：
port NO4
～
C4, Group 5:
port NO5, C5, NC5).Output alarm signal to the
alarm device. Please make sure there is power
to the external alarm device.

NO: Normal open alarm output port.

C: Alarm output public end.

NC: Normal close alarm output port.
C1
～
C5
NC5
A
RS-485
communication
port
RS485_A port. It is the cable A. You can connect to
the control devices such as speed dome PTZ.
B RS485_B.It is the cable B. You can connect to the
control devices such as speed dome PTZ.
CTRL 12V / Controller 12V power output. It is to control the on-off
alarm relay output. It can be used to control the
device alarm output. At the same time, it can also be
used as the power input source of some devices such
as the alarm detector.
+12V /
+12V power output port. It can provide the power to
some peripheral devices such as the camera or the
alarm device. Please note the supplying power shall
be below 1A.
RS-232 RS232 debug
COM.
It is for general COM debug to configure IP address
or transfer transparent COM data.
VGA
VGA video output
port
VGA video output port. Output analog video signal. It
can connect to the monitor to view analog video.
PoE PORTS /
Bult-in Switch. Support PoE.
The 16 PoE series product supports total 150W.
2.2.4
NVR8P8-4K
The professional 1U with 8 PoE ports series NVR rear panel is shown as below. See Figure 2-57.
Figure 2-57
Please refer to the following sheet for detailed information.