© 2005 Option Technologies Interactive, All Rights Reserved
Verifying the Keypad Addressess
1.
Hold the Clr key.
2.
Press 9-5-1 and then release the Clr key. Two horizontal bars will appear in the LED.
3.
Press *.
4.
The current three-digit address will flash in the display.
Changing the Keypad Channel
1.
Press and hold the Clr key.
2.
Press 973 and then release the Clr key. Two horizontal bars will appear in the LED.
3.
Enter the two digit code for the new channel. (Channels 1 - 15 are available) When using a channel less than
10, enter 0 before the channel number. (i.e. for channel 2, enter "0" "2").
Changing the Base Station Channel
1.
Set up the G2 base station.
2.
On the OptionPower menu, click Keypad Setup Wizard.
3.
Click Next.
4.
Click I need to change my keypad settings. I would like OptionPower to detect my ports, and then click Next.
5.
OK will appear as the status for the COM port on which the base station is detected. Click the port number
and then click G2 Mode.
6.
Select a new channel number, and then click Change to channel.
7.
Click Close.
Troubleshooting
Problem: The number pressed appears in the display but software does not receive the
response
Cause The keypad address is outside of the defined keypad universe.
Solution: Change the keypad address or change the keypad universe.
Cause:
The keypad is too far away from the base station.
