Lagom P64 User Manual v1.62
Rev date 28
th
October 2020
4. User Instruction
4.1. In the box
Lagom P64 will come with some parts packaged separately in the box for safe transport.
In the box, you should find the following:
i)
Lagom P64
ii)
Portafilter fork
iii)
Dosing funnel for 58mm baskets
iv)
Precision dosing cup
v)
IEC Power cord (optional, country-specific)
vi)
Silicone band (refer section 6.3)
vii)
Coffee mixer/WDT stirrer tool
viii)
RDT atomiser
Note: the fork and the power cord will come separately within the box. These need to be installed first
before the grinder can be used.
4.2 Using the Lagom P64
The Lagom P64 is designed to be easy and intuitive to use. This is the general workflow we recommend
as a starting point, but you may modify per your use case and preference.
1.
Measure out the desired quantity of beans.
RDT is mostly optional but may be helpful in some cases, such as with darker roasted
coffee or for coarse/brew grinding.
2.
Place the portafilter with the dosing funnel onto the fork.
3.
Load the measured coffee beans into the grinder, and switch on the power switch located on the
bottom-right side of the grinder.
You can load the beans while the motor is off or with the motor running (hot loading).
4.
Allow the coffee to complete grinding and dispensing*. Switch off the grinder.
5.
Stir the coffee in the basket with the WDT tool to distribute the grind (optional).
6.
Tamp and pull the shot.
*Note: In some cases, while that is not necessary, some users may prefer to tap the bean funnel using their
palm to clear any residual grind. We have found that is acceptable and only a gentle tap is required.