15 BRIDGE OUT
5
6
This RCA output send out bridge signal to another same X-series amplifier in bridging
configuration. All the functions will be adjusted by the master amplifier. Please see the
drawing of bridging in page 12.
This blue LED will light up when amplifier work properly. It will flash or shut down once
amplifier in self-testing or malfunction.
16 Run Indicator
17 Alarm Indicator
This red LED will light if amplifier has detected a fault or has shut down to protect
itself from permanent damage. This may caused by one of the following: excessive
heat, short circuit, low voltage, high voltage or overload. If this happens please shut
down the amplifier and check the problem.
Don't expose any cables out of car.Please take care insulated cables to avoid be
damanged when cables pass through metal, rubber and plastic etc. Don't install all
cables too tight.
Please use car audio RCA cables, otherwise it may be disturbed. Keep these cables as
short as possible. To avoid disturbances from your car electronics, please don`t close the
existing car cables when you install the RCA cables.
Table 1
The ground wire should be connected directly with the chassis of your vehicle which
should be metal to metal ground point connection.
The amplifier must be mounted securely at a solid, dry and low vibration surface in the
trunk or passenger area. Fix the amplifier in an open air area to insure proper heat
dissipation. Fix the amplifier in a place where can access easily to set input
controllers.
INPUT WIRING CONFIGURATION
Optional Remote Bass Level Control
OAX2000
5V Max Signal Input
Source Unit
14 BRIDGE IN
This RCA jack receives signal from the master amplifier when this amplifier is bridged as
slave. DO NOT use input jacks when the amplifier is working as slave. All the functions
will be adjusted by the master amplifier. Please see the drawing of bridging in page 12.
Model
Fuse
Cable
OAX2
0
00
150AMP
AWG 0-2#
12
Q-Control
18
Limit Indicator
This yellow LED will light if amplifier is driven to it’s power limit. This may occur when
amplifier output clipping, overload or overheat. When limit indicator light up, the
amplifier will reduce or hold output power to protect subwoofer and amplifier. Please
turn down volume or cool down the amplifier when this indicator light up continually.
This knob adjust the curve shape of bassboost. Turn it to narrow side will make the
boosted frequency narrow and sharp, turn it to wide side will extend the boosted
frequency range. Combining with bassboost frequency and bassboost level adjusting,
youcan achieve a perfect bass response matching your system.
Please prepare sufficiently to layout your car space before installation. We
recommend to have the installation done by an Autho rized
Dealer.
OPTION AUDIO
PRE INSTALLATION
Use good insulated power cable to endure up to 80A current draw. The +12 Volt power
cable must be connected with a fuse in line near 20cm of terminal. Required
current, power cable and proper external fuse listed as following.
OPTION AUDIO
