11
• If the cord or plug are worn or damaged, do not use.
• Unplug from the power socket by grasping the plug body – Do not pull on the cord.
Read and Save These Instructions
COMPONENTS
Below you will find an overview of the individual compo
-
nents:
1. Fan head with protective grill
2. Automatic oscillation > push / pull knob
3. Rotary switch: On / Off / 3 wind speeds
4. Wing screw to adjust tilt angle
5. Fixing screw: To fasten the fan joint to the stand
6. Screw for height adjustment
7. Stand
8. Round foot
9. Big washer
10. Small washer
11. Base screw: For fastening the foot to the stand
ASSEMBLY
The pedestal fan can be assembled in just a few steps. Proceed
as follows:
Remove all packaging material and perform the assembly on
an even surface.
First, connect the foot to the stand. In order to do so, place the
stand (7) on the foot and screw them together from below using
the washers (9, 10) and the included screw (11).
Ensure that the stand is set to medium height and the screw
for height adjustment (6) on the stand (7) is slightly tightened.
Now, take the assembled fan head (1) and insert the bottom part
of the joint into the upper opening of the stand (7).
CAUTION:
Ensure that the joint is adjusted
to prevent the fan head from pressing on the
stand. Otherwise scratches may occur! If neces
-
sary, straighten the joint beforehand using the
wing screw (4).
Make sure the threaded hole of the joint aligns with the bore on
the upper edge of the stand.
Next, screw the fixing screw (5) into the opening and the
thread. The fan is now ready for use.
Attention:
Always ensure that the fan head
does not come into contact with the stand when
tilted. Otherwise scratches may occur in the
matt lacquer finish. Especially when the oscilla
-
tion function is activated.
OPERATING INSTRUCTIONS
The fan has different functions that can be controlled via the
knobs on the fan. Proceed as follows:
1. Plug the power cord into a household outlet. The device is
designed for the voltage range 220 V– 240 V ~ 50/60 Hz.
2. Adjust the height of the fan using the screw provided (6).
3. Next, adjust the tilt of the fan head. Caution: Make sure that
the fan head does not come into contact with the stand when
tilted. Otherwise the matt lacquer finish may be scratched.
4. Turn the pedestal fan on using the rotary switch (3) on the
back of the device and select the desired wind setting. The
digits above the switch indicate the following:
Summary of Contents for WT-2741
Page 4: ...4...