Operation
Version 1.0.4 - 2020-09-08
37
Translation of original instructions
MZ2S
EN
MZ
2S
_G
B_4.
fm
4.2
Direct run
Use the torque button to facilitate the engaging of gear settings. The spindle begins to rotate
providing the torque button is pressed. For this, the spindle guard must be closed. Press the
torque button only briefly. The spindle drive on the control panel must be switched on for it.
Direct run spindle
Fig.4-4: Direct run spindle drive
4.3
Safety
Use the milling-machine only under the following conditions:
During operation
The milling machine is in proper working order.
The milling machine is used as intended.
The operating instructions are followed.
All safety devices are installed and activated.
WARNING!
Stop the machine immediately in the event of any abnormality in operation and make
sure it cannot be started up accidentally or without authorisation.
Notify the person responsible immediately of any modification.
WARNING!
Protect your eyes against filings and other fragments that might fly off at high speed.
Wear protective goggles.
CAUTION!
Different noise levels can be reached depending on the operation. Use ear protection!
CAUTION!
Wear protective gloves while setting up the machine.
Direct run
Emergency stop button
Recommended threshold values when lifting and carrying loads
Reasonable load in kg and frequency of lifting and carrying
Occasionally
More frequently
Age in years
Women
Men
Women
Men
15 - 18
15
35
10
20
19 - 45
15
55
10
30
from 45
15
45
10
25
