OPTIMUM
M A S C H I N E N - G E R M A N Y
Operation
Version 1.1.6 dated 2014-10-16
Page 74
Original operating instructions
F150
GB
6.4
Switching off the CNC machine
Push the EMERGENCY STOP push button.
For a long-term standstill of the CNC machine switch it off at the main switch.
"Disconnecting and securing the CNC machine“ on page 18
6.5
First insertion of a tool
When first commissioning the machine, the spindle is not located in a defined position. There is
no saved position in the control which indicates if there is a tool inserted in the spindle.
The message 700088 "Empty the tool spindle" is displayed.
In order to remove the non defined position, perform the following working steps for safety
reasons.
ATTENTION!
Hold your tool if there is a tool inserted in the spindle.
Turn the key switch
to the position <0>
Press the push button "Open/Close door"
and open the door.
Press the push button once before releasing the tool.
Img.6-4: “Manual tool change“ on page 75
Close the door again.
Press the push button <CYCLE START>
The axis travels to its maximum position, then close and open once the pneumatic acceleration
of the tool. Thus the process is completed.
Img.6-3:
Control panel
6.6
Insert tool
If you are working with only one tool which is directly inserted in the spindle it is possible to per-
form the inserting resp. changing in the operating mode "JOG". Press the corresponding push
button at the spindle head in order to "loosen" or to "clamp" the tool pneumatically.
ATTENTION!
Firmly hold the tool when you press the push button for "loosening".
1
2
3
3
2
1
