Optimum GC-1400, Instruction Manual

Page: 10 / 12

10
• Ensure that no object of any kind is within two meters of the
heater when it is use.
• Never use the heater near any inflammable material. It must
not be put near or in contact with any FUEL, OIL, GAS or
EXPLOSIVES.
• Do not use it outdoors.
• Do not position it directly below a power socket.
• Always position it on a flat horizontal surface.
• NEVER move or pick up the heater when it is turned on.
• Do not use the heater with a programmer or timing device
that switches it on automatically. The use of such devices is
dangerous and can cause a fire risk .
SYMBOL FUNCTION
– ON/OFF
– Fan only, no heat
I
– Low heat output
II
– Full heat output
OPERATION:
Plug the heater into a suitable power outlet observing all the
instruction regarding positioning and switch on.
To use the fan only function:
Turn the control dial to . The fan will blow out air at room
temperature.
As soon as the fan starts, the light above the switch will
illuminate.
To use the machine for heating:
Turn the control dial to “
I
” for low heat and “
II
” for full heat.
OVERHEATING:
The thermostat will turn the machine off it overheats.
Overheating can be caused by obstruction to the air intakes on
the back of the machine or the grill on the front .If this occurs
please disconnect the machine and allow it to cool for 30
minutes. Remove any obstruction and turn the machine back
on.
If the heater ceases to function, the most likely cause is a blown
fuse. Simply replace the 13amp fuse in the plug and reconnect.
If there is still no function please contact authorized dealer or
customer service.
CLEANING AND CARE:
There are no parts inside the machine that require your attention
or servicing. Do not try to open the outer case. By doing so you
could damage the motor and heating element and invalidate the
warranty. If you have a problem with the heater, or if the power
cord gets damaged in any way, you MUST take the unit to a
suitably qualified engineer or electrical repair centre.
Before cleaning the machine, please make sure it is
disconnected from the power supply, and has cooled down
completely.
Never cleaning the machine, please make sure it is disconnected
from the power supply, and has cooled down completely.
Never clean the machine with water and do not let it get wet
under any circumstance.
The outside case and be cleaned using a slightly damp lint-free
cloth (a small amount of detergent can be used if required).
To remove any dust particles etc. form inside the front grill,
or the rear air intakes, you can use a regular vacuum cleaner.
Always make sure the machine is completely dry before using.
If you are not going to use the heater for a while it is best to
make sure it is clean and dry and then store it inside a plastic
bag in a cool dry place.
With sensible care and attention this heater will give you many
years of good service and economical heating.
OPERATING INSTRUCTIONS FOR MODEL
GC-1500
DESCRIPTION
A – ON/OFF
B – OSC for oscillation
C – 750 W heat setting
D – 1500 W heat setting
OPERATION:
Stand the heater on a horizontal, flat and even surface and at
least 120 cms of safe distance to walls, subjects, furniture and
buildings. Do not stand on an unstable surface, e.g., to a bed or
a langflor carpet (the appliance could upset). Pay attention to
the safety regulations named at the top.
I
II
ON/OFF
Fan only, no heat
Low heat output
(700 W)
Full heat output
(1400 W)