Safety
Version 2.1.2 dated 2018-09-13
Page 15
Translation of the original instructions
B17Pro | B23Pro | B26Pro | B33Pro
GB
B17_
B23_
B26_
B33_
GB_
1
.f
m
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
It is not possible to start the machine until the protective cover is closed.
Img.1-2:
Protective cover
1.10.2 Drill chuck protection
Adjust the protective equipment to the correct
height before you start working.
To do so, detach the clamping screw, adjust
the required height and re-tighten the clamp-
ing screw.
A switch is integrated in the fixture of the spin-
dle protection which monitors that the cover is
closed.
INFORMATION
You cannot start the machine if the drill chuck
protection is not closed.
Img.1-3:
Drill chuck protection
1.11
Drilling table
Seats for T-slots are attached to the drill-
ing table.
WARNING!
Risk of injury due to parts flying off at
high speed. Securely fix the workpiece
on the drilling table.
Img.1-4:
Drilling table
1.12
Prohibition, warning and mandatory signs
INFORMATION
All warning signs must be legible. They must be checked regularly.
1.13
Safety check
Check the drilling machine at least once per shift. Inform the person responsible immediately of
any damage, defects or changes in the operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped),
once a week (with the machine in operation),
after all maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the drilling machine.
are legible (clean them, if necessary)
are complete.
INFORMATION
Organise the checks according to the following table;
Drill chuck pro-
tection
seats for clamping
blocks
