®
OPTIMUM QUALITY MAXIMUM RELIABILITY
TM
3
TMS300 OPERA
TING INSTRUCTIONS
Safety instructions
Before operation
a. Read the instruction manual
b. Verify that the mains supply voltage is correct for the strapping machine and is properly earthed
c. This strapping machine can only be used with polypropylene (PP) strap; do not use polyester (PET)
or polyethylene (PE) cord strap
d. Before operation ensure the area around the strapping machine is clear and safe.
During operation
a. Wear appropriate personal protective strapping machine (PPE) while operating this strapping machine
b. Do not attempt to strap any package exceeding 100kg
c. Do not attempt to strap a package less than 80mm wide or 20mm high
d. Immediately suspend operation if smoke or unusual sounds are observed
After operation
a. Remove all dust and dirt from the strapping machine, paying particular attention to the inside of the arch
b. Turn off the power supply when the strapping machine is not in use
General safety remarks
Basic safety precautions
a. The strapping machine is only to be operated when in good running order and in following the instructions
provided in the operator manual, in accordance with its designated use
b. Operators must be properly trained in strapping machine operation procedures and operator safety
Safety warning symbols
Maintenance
a. Always disconnect mains power supply before removing either of the top covers
b. Always use the correct tools and parts to service and repair the machine
c. Be aware that the heater assembly may still be extremely hot and cause burns if touched
Location
a. The strapping machine must always be located in a low-humidity environment
b. Do not expose the strapping machine to extremes of temperature
c. Position the strapping machine on an even floor, to prevent distortion that may cause malfunction
Other
a. Keep the operator manual with the strapping machine at all times
b. Do not modify the strapping machine or its circuitry including safety interlocks, unless specifically
authorised to do so by the manufacturer
c. Do not operate the machine with any covers removed
d. Only use the machine within the parameters of its stated performance.
Risk of electric shock
Hot surface,
do not touch