Optimal 30.25, Manual

Page: 14 / 42

- 14 -
5.8 Replacing Plastic Lining and Sliding Disk at Blade Guides

Put the blade in to the lowest position

remove screws M8 (G) and draw blade
(H) down until free.

replace worn plastic linings and screws
by new.

In case that the sliding disks are also
worn, they must be replaced by new
ones.

Use only new original parts.

installation is done in the reverse order.
Tightening torque:
- screws (G) to fasten blade (M8x20): 42 Nm
H
G
K
J
J