Optima OP-2200, Operating Instructions Manual, Page: 15 / 20

15
INSTRUCTION
ASSEMBLY OF COMPONENTS
COMPONENTS
A. Pushing cylinder
B. Inlet orifice
C. Tray
D. Upper cap
E. Extracting Rod
F. Fixer
G. Squeezing cup
H. Drep mouth
I. Juice mouth
J. Drep cup
K. Juice cup
L. Main engine
M. Power switch
N. Brush
Disassembly is in the opposite sequence of assembly.
Notice:
1. Before assembly, make sure the sealing strip on the
bottom is inserted properly.
If the sealing strip is not inserted properly, juice shall flow
outside or become less. See Fig. 2.
2. Before assembling the squeezing cup, make sure first
whether the middle sealing ring is set well.
If the sealing ring is not set well, juice shall flow out from
the middle. See Fig. 2
1. Using the mark point on the squeezing cup to aim at the
mark point of the big main engine, put on the main engine
as the figure, clockwise rotation. See Fig. 3a, b.
2. Select required extracting rod, assemble it to squzzeing
cup as figure. See Fig. 4a, b.
Sealing ring
Notice: a. Bottom of squeezing cup, b. Inserting direction of sealing strip
a b
Fig. 2
a b
➀
➁
Fig. 3