PR EVB User’s Manual
3 of 7
Optilab, LLC
600 E. Camelback Road, Phoenix, AZ 85012
Phone: (602) 343-1496, Fax: (602) 343-1489, Email: [email protected]
2.
Evaluation Board
The Evaluation Board for the PR-30 is used for ease of testing. It provides
convenient access to all 14 pins and the data output ports. Utilizing a zero-
insertion force configuration, the device can be mounted without the need for
soldering as a user-friendly interfacing solution. The EVB is mounted on a
base plate. The base plate can be further mounted to other structures using the
four ¼-20 threaded through holes
2.1 Device Mounting Procedure
i)
Place PR-30 onto the evaluation board as show in Fig. 2. Pay attention to its
orientation. The label P and N denotes the positive and negative RF output
ports.
ii)
Align pins down into pin chuck. Make sure that they line up and don’t cross
over.
iii)
Mount PR to Evaluation board using the four
2-56
screws provided.
iv)
Once secured clamp pins down in pin chuck, as shown in Fig. 3.
Figure 2. PR-30 mounting procedure