Optika Italy SZ-STL5, Instruction Manual

Page: 7 / 40

Page 7
Adjusting the Mount Bracket Resistance
1. Product is brilliantly engineered to control the resistance in the Tilter Mount Bracket to suit swing side to side
of 90 degree and tilt forward and backward of 90 degree. It is possible to control the amount of resistance in
the Tilter Mount Bracket.
2. If the Tilter Mount Bracket tends to automatically fall, it may be required to adjust the Tilter Mount Bracket
joint to suit your microscope tilt position of forward and backward of 90 degree. This can be done by using
Hex Allen Wrench 6mm to increase the resistant of the Tilter Mount Bracket in order to secure tilt position,
adjust the M5x15mm Tension Hex Socket Cap Screw located around the Tilter Mount Bracket Joint using
6mm Hex Allen Wrench. (See Figure 5).
Figure 5
3. To increase or decrease the resistance of the Pivot Joint to suit microscope swing side to side, adjust the
Tension Hex Cap Screw located on front side of the Articulating Arm to secure the position. (See Figure 6).
4. To increase the resistance, tighten the M5x15mm Tension Hex Cap Screwn using Allen Wrench 4mm in a
clockwise direction. To decrease the resistance, loosen the M5x15mm Tension Hex Cap Screw using Allen
Wrench 4mm supplied in an anti-clockwise direction.
Figure 6
DETAILED VIEW
DETAILED VIEW
PIVOT JOINT
MICROSCOPE SWING-SIDE TO SIDE