Opticon, Inc.
http://www.opticon.com
2.2 Hardware Installation
1. Connect the Ethernet cable to the CRD-19-E4 Ethernet Uplink and the other end
to Ethernet switch/hub*.
2. Connect the power adapter to DC Jack of the CRD-19-E4, then into the wall
outlet. If power is present, the CRD-19-E4 will proceed with normal power on
sequence.
3. Once the CRD-19-E4 is ready, the Power LED will blink YELLOW.
To shut down the CRD-19-E4, remove all H-19 devices from device pocket and
disconnect the AC power adapter.
Do not shut down the CRD-19-E4 when there is a
PDA performing data communications since this may cause data to be lost.
Notes
:
* In a non-DHCP environment, the system administrator must set up an enclosed
DHCP network to access and modify the CRD-19-E4’s configuration using the
browser-based
CRD-19-E4
Administration Tool
.
Page
7
