Installation
Important: Please keep the installation procedure below. Improper or no
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Plug the 5V power adapters to the power jack of the transmitter and receiver.
Ensure the Power LED ON (Blue) and Status LED blinking slowly (Blue).
Step 3
Please, check if the maximum resolution of the display is WQXGA
(2560x1200). Otherwise, follow the instructions for
Self-EDID Programming
Procedure
on page 1-5.
Step 4
Connect two (2) LC optical fibers between the transmitter and the receiver
and each fiber channel shall be connected as 1 to 1 and 2 to 2 carefully and
ensure the duplex connectors are fully engaged.
Figure 2
– Fiber numbering and Status LED position on a label
1-3 Installation
Step 5
Plug the transmitter to the DVI receptacle of the DVI source such as PC and the
receiver to the DVI receptacle of the display as shown in figure 3.
Figure 3
– Connection of optical fiber
Note1:
The maximum extension length by multi-mode fiber is 500 meters.
Note2:
Be recommended NOT to use any intermediate cable or adapter
between them to avoid undesirable performance degradation.
Step 6
Make the PC and the display power ON. And ensure that the Status LED in
transmitter and receiver turn on.
1-4 Installation
Tw
o (2)
O
ptical
Fiber
DDFX-100
Tx
DDFX-100
Rx
