Installation
Important: Please keep the installation procedure below. Improper or no
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents in the shipping group.
Step 2
Power on the HDMI source and display. Power on both transmitter and
receiver by using DC power adapter or USB power cable to Receiver (Rx).
Note1:
Only Receiver (Rx) can be operated by USB power cable.
Step 3
Then, the LED (Green color) will begin to blink once a second for three (3)
times regularly on both sides.
Figure 2
– Position of the LED
Step 4
Connect two (2) LC optical fibers between the transmitter and the receiver
and each fiber channel shall be connected as A to A and B to B carefully.
Ensure the duplex connectors are fully engaged and then, the top LED will
begin to blink regularly.
Fig Figure 3
– Fiber numbering & Caution on both fiber ports
1-3 Installation
Position of the LED
Note1:
The maximum extension length by multi-mode fiber is 300 meters.
Note2:
Be recommended NOT to use any intermediate cable or adapter
between them to avoid undesirable performance degradation.
Fig Figure 4
– Connection of optical fiber
Step 5
Connect the transmitter to the HDMI source over HDMI copper cable.
Step 6
Connect the receiver to the HDMI display over HDMI copper cable.
Note:
If the connectors are fully engaged, the bottom LED will turn on.
Step 7
If the system does not work properly, go to the page 1-5 trouble shooting.
1-4 Installation
