Troubleshooting
The display shows only black screen
.
- Ensure that all plugs and jacks used by USB to DC plug cables or DC power
adapter are firmly connected. Ensure that the LED ON.
- Ensure that the HDMI ports are firmly plugged in to the source and display.
- Ensure that the transmitter and receiver modules plugged correctly to the source
and display respectively.
- Check if the HDMI source and display are powered on and properly booted.
- Reset the system by de-plugging and re-plugging the transmitter HDMI port or
receiver HDMI port, or by de-plugging and re-plugging the USB to DC plug cables
that are plugged to transmitter and receiver module
- Re-boot up the system while connecting the module.
Screen is distorted or displays noises.
- Check if the graphic resolution is properly set. Go to the display properties and tap
the settings. Ensure that the resolution sets less than WUXGA (1920x1200) at
60Hz refresh ratio.
- Reset the system.
- Power down, disconnect and reconnect the optical system cable or DC power
adaptors, and power up.
1-5 Troubleshooting
Maintenance
No special maintenance is required for the optical system cables and power
supplies. Ensure that the cables and power modules are stored or used in a
benign environment free from liquid or dirt contamination.
There are no user serviceable parts. Refer all service and repair issues to Opticis
or its authorized distributor.
Technical Support and Service
For commercial or general product support, contact your reseller. For technical
service, contact Opticis by email
or visit its website at
www.opticis.com
.
1-6 Maintenance, Technical Support
,
and Service
