-1-
INSTALLATION INSTRUCTIONS
No.59-2069-1 1701-31
INSTALLATIONS
PCU-5 ×1, Putty ×2, Insulation Plate ×1
Power Convertor Unit
PCU-5
PARTS IDENTIFICATION
BATTERY OPERATED
PHOTOELECTRIC DETECTOR
Smart Line series
OPTION
BATTERY OPERATED
PHOTOELECTRIC DETECTOR
Smart Line series
OPTION
™
™
1
2
3
Connect the connector cable to the
terminals of PCU-5.
4
5
7
8
9
6
Note>>
Put the cables in order not to be caught
between the main unit and cover.
Using a screwdriver or similar tool, break
the knockout position in the back box as
shown.
Open the battery plate and then route the
control panel wires from the rear of the back
box through the knockout holes.
Adjust the wires so that they extend about
100 mm from the holes.
Fill the holes with the wires using the
supplied putty.
Close the battery plate and connect PCU-5
male connector to the female connector of
the battery plate.
Route the three connectors of the back box
through the slit on the upper part of the
main unit of the receiver. For the transmitter,
wire the two connectors in the same way.
Attach the connectors.
Insert the insulation plate and PCU-5 as
illustrated. And then connect the wires to
the PCU-5 terminals.
Route connector cables (Alarm, Low battery
and Tamper, included in SL-100/200TNR) in
the back box through the hole to the battery box.
Control panel
For the receiver, the step 2 & 3 are applied. For the transmitter, jump to the step 4.
CP Side
DETECTOR
Side
The length of the wire
should be about 100 mm.
Insulation sheet
Voltage convertor unit used to enable wired
operation of the detector.
For
SL-100/200TNR
only
Insert the PCU-5
board to the left side.
CP Side
Detector Side
www.GateOpenerSafety.com | (800) 878-7829 | [email protected]
