PoE IP Encoder
PIE-1
PoE IP Encoder
PIE-1
INSTALLATION INSTRUCTIONS
( for SIP series and RLS series )
No.5919420
▪ PIE-1 changes analog relay output signals (N.C.) to
original ASCII code.
▪ PIE-1 can supply power to detector using a PoE hub
or switch.
▪ Follow all cautions and instructions in this manual
before installation.
▪ Keep this manual after installation so that you can
read when necessary.
▪ Remember the meanings of “Warning” and
“Caution” below to use the product safely.
If you ignore a caution, the user or other
people may be injured or the product or
something around it may be damaged.
If you ignore a warning, the user or other
people may be injured or dead.
▪ Do not repair, dismantle or modify the product
yourself.
▪ Do not touch the product with a wet hand.
▪ Be careful not to damage other interior wiring when
installing or wiring the product.
▪ Power off the product immediately if smoke, odor or
strange sound emits from the product.
▪ Do not install the product in an extremely moist place
such as a bathroom or a place where the product
may be wet.
▪ Insert the connectors securely when wiring.
Caution
■
No. 6-32 UNC screw (5/8 inch), 6 pcs
■
Alarm 10-pin cable (26cm)
■
Power 2-pin cable (26cm)
■
Alarm 6-pin cable (10cm)
■
Alarm 4-pin cable (10cm)
■
Power 2-pin cable (10cm)
■
Main unit of PIE-1
SAFETY PRECAUTION
FEATURES
Connectors
Warning
Warning
Warning: This is a class A product. In a domestic
environment this product may cause radio interference
in which case the user may be required to take
adequate measures. (EN55022)
CE Statement
Warning
Caution
■
SIP mounting plate
for Gang Box
■ Gasket sheet
for Gang Box
PARTS IDENTIFICATION
1
Ethernet connector for PoE
Ethernet connector for detector
24VDC Power output connector
12VDC Power output connector
Alarm input connector
▪
Be sure to use the attached cables.
▪
Do not use 12V and 24V power sources at the same time.
Caution
