- Accessories
2
- Parts identification
1
Installation
Step
Mounting Screw &
Plastic Anchor-4pcs
Mounting Template
Cable Hole.
Mounting Bracktet
DC Plug Jack
Screw 1pc
Speaker
Lens
Mic
LED
PIR Sensor
Illumina
ti
on Sensor
Main unit
Base unit
SD Card Slot
Lan Port
12V DC Port
Alarm
Terminal Port
Reset / WPS
Main unit (Rear side)
1-1. Install the mounting bracket
Wall mount
Corner mount
Mounting screw x 2
Mounting template
Mounting bracket
Mounting screw x 4
1-2. Remove the main unit from the base unit
1
2
Remove the accessory screw, if already installed.
Press the buttons on the
both sides to release the
main unit.
2
1-3. Install/Remove an SD Memory
Card (optional)
5
1-4. Wiring
To Alarm Terminal Port
To LAN Port
To 12 V DC Port
Reset / WPS
Main unit (Rear side)
Factory reset
Press the rest button for 5 seconds
to return the setup to the factory default.
If you press the Reset button, you will lose all the setting data.
If needed, make a note for further installation.
T1 T2
+12V
GND N.O COM N.C
Power source Consumption
12 V DC 6.4 W
IEEE 802.3af Class 3
6.8 W
1
2
3
1
Powe connection
Check the voltage and current capacity
of the power source before connecting.
2
Network connection
Connect the crossover cable into the RJ-45.
3
Alarm connection
T1: Tamper switch
T2: Tamper switch
NOTE
Warning
Caution
Install
Remove
N.O.: Normally open
COM: Common
N.C.: Normally close
+12V: 12 V DC power
GND: Ground
- CHeKT account
If you do not have a CHeKT account, request a dealer
account by visiting the "CHeKT dealer", before Step 3.
Refer to the “CHeKT support" for more details.
CHeKT support
https://support.chekt.com
CHeKT dealer
www.chekt.com/registration
