SKULL MOUNTING SYSTEM SETUP
•
Turn Adjustment Dials counter-clockwise (left) to make the Skull Mounting System is fully open.
•
Place open Skull Mounting System on your head so that the Front Plate is centered over the
bridge of your nose. Begin adjustment by firmly pressing down on the top of the Front Plate while
tightening the Rear Adjustment Dial (turn clockwise to tighten).
•
The distance from the top of the eyebrow to the bottom of the Skull Mounting System should be
approximately 0.5” - 1” as shown. The bottom of the Rear Pad should rest above nape of the neck.
FIT DIAL
OPERATION
•
Proceed to tighten the front and rear Top
Adjustment Dials until the Skull Mounting
System fits securely on head. Readjust
dials as desired to achieve comfortable fit
and positioning.
•
Once the front and rear Top Adjustment
Dials are set, the Rear Adjustment Dial
may need to be tightened again.
Right Side
Side Pads
0.5”-1”
Chinstrap
Buckle
Front
Head-Loc
Slider
Rear
Adjustment
Dial
TIGHTEN
(Skull Mounting System Fully Closed)
TURN DIALS CLOCKWISE TO TIGHTEN
LOOSEN
(Skull Mounting System Fully Open)
TURN DIALS COUNTER-CLOCKWISE TO LOOSEN
Side Rail
Adjustment Dial
Rear
Comfort Pad
Chinstrap Buckle
(LED Version Available)
Head-Loc
®
Adjustment Sliders
Front
Plate
Large Counterweight
(with 11/4” Screws)
Small Counterweight
(with
5
/
8
” Screws)
(Back of Skull Mounting System)
Attached
Counterweight
CHINSTRAP OPERATION
•
Fasten the Chinstrap Buckle. With both hands, pull the two Rear Head-Loc Sliders on
the lower webbing straps toward your chin until snug.
•
With both hands, pull the two Front Head-Loc Sliders on the webbing straps that come
from the front temples of the Skull Mounting System toward your chin until snug.
Rear Pad
Rear
Left Side
Front Plate
Top
Adjustment
Dials
Rear
Head-Loc
Slider
ABOUT YOUR SKULL MOUNTING SYSTEM
This manual covers the basic operating and fitting instructions for the Ops-Core Skull Mounting System. The
Skull Mounting System is a multi-purpose headgear integration device that is compatible with a variety of
attachments. The Three Dial Adjustment system accommodates a full range of head shapes and sizes.
INTRODUCTION
COMFORT PAD SETUP
The Skull Mounting System is designed to fit the majority of head
sizes. However, some users with smaller head sizes may find the
thin pads to result in a loose fit. If this occurs, replace the back and
side pads with the thicker comfort pads shown in dark grey.
COUNTERWEIGHT KIT
(OPTIONAL)
If you purchased a Counterweight Kit with your Skull Mounting
System kit includes (1) Small and (1) Large Counterweight with
corresponding hardware.
COUNTERWEIGHT
ATTACHMENT
NOTE: ONLY ATTACH A COUNTERWEIGHT IF YOU
NEED TO COUNTERBALANCE AN ATTACHMENT
AT THE FRONT OF THE Skull Mounting System.
Align Counterweight holes to the holes on the back of the Skull
Mounting System. Hold Counterweight in place and use your
fingers to loosely attach a screw through the Counterweight and
Skull Mounting System. Repeat for the remaining 2 holes.
Finish by using a screwdriver to tighten all 3 screws from the
outside of the Counterweight, making sure the Counterweight
is securely fastened to the Skull Mounting System.
FIT & ADJUSTMENT
