4
E108948#1
9.
Conect up the components as shown in the wiring diagram.
You can make the connections by simply twisting the ends of the cables together on the contacts. To do this remove about
6-8mm from the insulation at the cable ends to expose the inner wires and twist them carefully aound rhe contacts
Or you can solder the connections. Remove the insulation from the cable (14) as above and carefully solder on to the con-
tacts.
Guide the cable ends from the battery holder through the free hole in the metal strip (To the right on the plan view)
10.
Insert the battery (Watch the polarity!) and check the circuit connections
To begin with the ROBO-Bee will travel go forwards.until it hits an object, the switch contact will be made, and the motors
will change over and the Robo bee will reverse until the switch is free again.
If this does not work check the circuitry.
If the Robo bee- turns in a circle, one of the motors is wrongly,connected check with the wiring diagram
red cable =+-Pole
Connect the motors as
shown
UNDERNEATH
TOP
+-Pol
ca. 60mm
--Pol
ca. 60mm
ca. 100mm
ca. 80mm
ca. 100mm
ca.100mm
ca. 40mm
black cable=--Pole
Summary of Contents for ROBO-Bee
Page 6: ...6 E108948 1...
