2
D108465#1
Instructions
1. General: Using the materials given the cube can be made to the instructions or your own design ( The full size
patterns are on page 5 )
Note:
The holes are 10mm diameter. The pine strips for the labyrinth must have a gap of 11mm.
2. Check the design for your labyrinth carefully before starting to cut any wood.
Make up a cutting list for the pine strips.
3. Mark out and saw four squares 90 x 90 mm from the acrylic ( See diagram 3 )
4. Mark out the position of the hole on the acrylic sheet. 1
5. Drill the 15mm hole with a pillar drill ( Drill in two steps first use a smaller drill )
(Please take care to adhere to the safety rules when drilling and use a scrap piece of wood as an underlay)
Note!
You can drill both top and bottom holes at once. The position of the second hole is marked on the plan with a bro-
ken line.
6. Cut the pine strip according to your list ( Take care with the quantity of material supplied )
7. Sand the pine strips
8. Glue the strips on the acrylic ( See diagram 3+4 ) Use UHU all purpose
or a similar glue
Note!
Take care with the position of the holes
9. Once dry you can assemble and glue the layers together. The best way is layer 2 with layer 3 & then layer 1 with the
lid. Leave to dry and then glue layer 1 to layer 2
Hinweis:
Position der einzelnen Ebenen beachte, dass nicht 2 Bohrungen übereinander liegen!
10. Den Cube außen versäubern und evtl. die Holzfläche mit Lack, Wachs usw. behandeln.
Viel Spaß mit dem Labyrinth-Cube!
Layer 1
Lid
Layer 2
Layer 3
