4
E115855#2
40
80
12,5
Ø
4
90
25
25
40
80
12,5
Ø
4
90
25
25
90
90
80
80
12,5
Ø 4
25
40
90
110
200
100
50
12
15
15
12
12
Ø 10
5
5
20
50
Ø 3
22
Ø 7
A
B
15
15
100
10
7
5
2
A
B
15
15
100
10
7
5
2
11. Cut the wooden strip (7) as shown. Mark the center of a 80mm strip and
drill a hole ø 4mm into it.
Instructions to build the control:
2x
12. Cut the plywood (1) as shown in two parts with 90mm and 110mm. Take the piece which is 110mm long and saw the
opening for the slide switch.
Next drill two drill holes, ø2,5mm, for the push buttons next to the opening. Additionally turn around the plate and
drill a 2mm deep hole with a diameter of 10mm directly over the ø2,5mm drill hole. After that turn around the plate
again and drill one more hole with ø7mm over the existing ø2,5mm drilling hole on each side. For future mounting
drill 4 holes ø 3mm into the base, as shown (1a).
1
1a
1b
7a
7b
7c
7d
13. Glue the pieces 7a-7d on the base (1b), as shown.
7a
7b
7c
7d
1b
14. Glue the slide switch(13) into the opening (Teil 1a) and
put the two push buttons into the drilling holes. Fix them
with the appendant nuts.
1a
Cut
