Opitec 107.388, Manual

Page: 8 / 13

8
D107388#1
8
D107388#1
6.3.5 Bend the two spring (7) contacts as shown.
6.4 Final assembly and testing:
6.4.1 Machine screw (9) and bolt ( nuts 10) the magnets to the U shaped holder or glue them in place.
Note ! Check the polarity of the magnets !!
Fix the magnets to the holder type as shown
6.4.2 Screw the bearing strips to the base as shown using two machine screws (11)
Ensure that the hold the shaft and that it can turn easily.
Now screw (11) on the U shaped holder checking that the rotor can turn easily
Now mount the two contact springs using the screws (11) and washers and check that the have a light contact with
the copper wire
6.4.3 Connect to a 4.5 volt battery and give the rotor a light twist and
the motor should run !
Note : apply a few drops of oil the bearings and the
contacts!
40,0 40,0
20,0
95,0
Ø 1,0
90,00
°
5,0
30,0
30,0
15,0
5,0
S
N
2x