3
6
Press the brass tube (5) in the bearing blocks.
5
Insert the screws (9) in the 2mm holes.
7
Connect the lever and bearing blocks (6) and stop nut (7) so that the
leber is easy to use.
8
Connect the lever and bearing blocks (6) and stop nut (7) so that the
lever is easy to use. Place the bearing blocks on the base and screw
them cantrally in place from undemeath through the pre-drilled 2mm
holes using the screws.
9
Finally glue a piece of modelling foam unermeath to make a non slip
surface.
Instructions 106.809
Table top nutcracker
9
10
Once tested the table to nutcracker can be decorated.
Any excess thead on the set screw (6) up to the stop nut (7) can be
sawn off with a junior hacksaw and filed flat.
5
6
7
8
10
10
