Opitec 102.056, Assembly Instructions Manual

Page: 6 / 25

6
E102056#1
7.1.6 Fit the boom spar (3)into the nose and glue it into position.
7.1.7 Drill the 5mm dia holes into the lead weight chambers (These holes will be covered with sellotape at a later
stage)
7.1.8 Cut two 25mm lengths from the dowel 3 dia x 150mm. Use a modelling knife (roll the dowel under the
blade) Using the plan as reference glue one dowel at the front end of the nose and the other at the end
(see plan)
Note:
Do not cut both of these pieces from the same length of dowel!
7.1.9 Sand the nose and then chamfer the cladding edge at 45 degrees (See sketch)
7.1.10 Mark and cut out the wing carrier (4) as shown on page 5 and glue it in position (see diagram)
Note:
Note the direction of the grain
7.1.11 Glue the side dowels (5) 3 dia x 125mm ( remainder from step 6.1.8) in position as shown in the diagram
45°
20
62,5
125
3
4
4
4
4
Esq 2