Pitney
Bowes
Operation
53
Omation Series 210™ Envelopener® Operator Manual
OPEX Corporation
3.
To deepen the cut, begin by turning the cutter depth screw 1/4 turn the right
using a Phillips screwdriver (Figure 4-18).
Figure 4-18: Adjusting the cutter depth
4.
Replace the cover and run an envelope through to verify if it has been cut
now.
5.
Repeat steps 3 and 4 until the envelopes are being cut open. If you find the
cut is too deep, turn the screw to the left in 1/4 turn or smaller increments
until you have the envelope being cut without cutting the contents.
Turn right in 1/4 turn
increments for a deeper cut
This PDF has been created for exclusive use for
Pitney Bowes
This PDF has been created for exclusive use for Pitney Bowes
This PDF has been created for exclusive use for
Pitney Bowes