50
Operation
Model 72™ Operator Manual
OPEX Corporation
4.8. Setting cutter positions
The side and top cutter on the Model 72 are operator-adjustable (Figure 4-22).
Figure 4-22: Cutter levers
The top cutter has five positions:
•
POSITION 0
- No Cut (knob fully left)
•
POSITION 1
- Normal (0-.060” / 0-1.52 mm)
•
POSITION 2
- .015” / +0.38 mm
•
POSITION 3
- .030” / +0.76 mm
•
POSITION 4
- .094” / +2.39 mm (knob fully right)
The side cutter has four positions:
•
POSITION 0
- No Cut (knob fully right)
•
POSITION 1
- Normal (0-.060” / 0-1.52 mm)
•
POSITION 2
- 1/16” (1.59 mm)
•
POSITION 3
- Deep Cut (knob fully left). This is approximately a 1/2”/(13
mm) cut.
Deep Cut
No Cut
Deep Cut
No Cut
TOP CUTTER
SIDE CUTTER
Summary of Contents for Model 72
