102
Maintenance
FalconV User Manual - Standard Scanning - OPEX Corporation
Attaching the bins and stacker fingers
This procedure describes how to install the upper and lower stacker fingers.
Stacker finger(s) will need to be reinstalled if they become dislodged or broken.
It is best to remove the bins for easier access when reinstalling them. Simply
pull the bins out and set them aside.
Lower Stacker Fingers
The lower stacker fingers come pre-assembled and only need to be put in place.
Load them into the slots at the bottom of each bin base.
Keep the end of the stacker finger centered in the slot, and push down the
bottom of it so the finger’s pin can slide underneath the small tabs on each side.
Release it, and the spring inside will hold it in place against the tab.
Note:
When installing the lower finger, it is important that the finger must be
oriented at an upward angle as shown. If the finger is held down flat, it is
not possible to install it.
Note:
On production machines, the stacker fingers are black. The white
stacker finger shown above was used to provide better contrast in the
photo.
Push down so pin
goes under tab
Keep end
aligned to slot
Summary of Contents for FalconV
Page 5: ...5 FalconV User Manual Standard Scanning OPEX Corporation Performance Details statistics 119...
Page 6: ...6 FalconV User Manual Standard Scanning OPEX Corporation...
Page 82: ...82 Operation FalconV User Manual Standard Scanning OPEX Corporation Figure 24 Ending the job...
Page 110: ...110 Maintenance FalconV User Manual Standard Scanning OPEX Corporation...