Opera AMLETO IDRO, User Manual

Page: 29 / 40

29 ENGLISH
CHRONO
The chrono allows to program 4 time spans within a day to use every day of the week.
The switch-on and switch-off time can be set in every time span. along with the
days of use of the programmed time span and the desired H2O temperature (65
- 80°C).
RECOMMENDATIONS
The ignition and switch-off times must be within the arc of
one day, from 0 to 24 and not over several days:
Before using the chrono function, set the current day and
time. Therefore check that the points listed in the “ Set clock ”
sub-chapter have been followed, so that the chrono function
works. Aside from programming it, activate it as well.
Example:
Switch-on time 07:00 CORRECT
Switch-off time 18:00
Switch-on time 22:00
INCORRECT
Switch-off time 05:00
RESET
Allows to reset all values modifiable by the user to the default values. The modified data are:
CONTROLS PROCEDURE
Š
Press the key 6, SET CLOCK will appear.
Š
Press key 2 several times until " USER " is displayed
Š
Press key 6.
Š
" SET THERMOSTAT " will appear
Š
Press key 2 until " RESET " is displayed.
Š
Use keys 4-5 to select ON and press key 6.
Š
The word " DONE " will be displayed to confirm
Š
SET H2O = 75°C
Š
SET TEMPERATURE = 35°C
Š
SET POWER = 5
Š
ENABLE CHRONO = OFF
Š
START PRG1=OFF
Š
STOP PRG1 = OFF
Š
MONDAY PRG1 = OFF
Š
.......all chrono parameters OFF
Š
PELLET = 00%
Š
STAND BY = OFF
KEYS LOCKED
The menu allows to lock the display keys (like mobile phone). Press keys 1 and 5 simultaneously.
With the function activated, “
KEYS LOCKED
” will appear every time a key is pressed.
CONTROLS PROCEDURE
Š
Press the key 6,
SET CLOCK
will appear.
Š
Press key 2 several times until "
USER
" is displayed
Š
Press key 6.
Š
"
SET THERMOSTAT
" will appear
Š
Press key 2 until "
KEYS LOCKED
" is displayed.
Š
Use keys 4-5 to enable/disable.
Š
Press key 6 to confirm and 1 to return to the menu
back to the initial status.
AIR DISCHARGE
This function allows venting any air in the stove. Upon activating the function: The indicator lights of the circulators will light up on the display.
(the pumps will be powered for 15 minutes and 30 seconds and then will stop for 30 seconds; cut the power to interrupt)
CONTROLS PROCEDURE
Š
Press keys 1 and 4 simultaneously.
Š
You will be prompted to enter the password.
Š
Enter code "77", using key 4
Š
Confirm using key 6.
29