background image

 

 

 

 

Power Lines 
In case of connecting a tuner, an outdoor antenna should be located away from power lines. If 
an outside antenna is connected to the system, be sure the antenna is grounded so as to 
provide some protection against voltage surges and built up of static charges. 

Lighting 
Consonance hi-fi system can be damaged by lightning. Power amplifiers are particularly at 
risk and therefore should be turned off when there is risk of lightning strike. For complete 
protection all mains plugs and any aerial cables should be disconnected when not in use. 

Cleaning 
Never clean with furniture polish, benzene, or volatile liquids. Dust periodically with a clean, 
soft paint brush. Fingerprints can be removed with a moist polishing cloth.  

Ventilation 
The equipment should be situated so that its location or position does not interfere with its 
proper ventilation.  

1.  The equipment must not be placed on bed, sofa, or similar surfaces, that may block the 

ventilation openings,  

2.  The equipment must not be placed in a built-in installation, such as a bookcase or cabinet 

that may impede the flow of air.  

3.  The equipment should be situated away from heat sources such as radiators, heat 

register, stoves, or other electronic appliances that produce heat. This equipment is not 
intended for commercial use. 

Water and Moisture 
The equipment should not be used near water, e.g., near a bathtub, washbowl, kitchen sink, 
laundry tub, in a wet basement, or near a swimming pool etc. Similarly, do not placed objects 
filled with liquid, such as vases on top of the equipment. 

Speaker Impedance 
For best performance, the load presented by the speaker has to match the CYBER-300BD’s 
output impedance per channel. Refer to the speaker’s manufacturer handbook for information 
on the nominal impedance. The CYBER-300BD is factory set to match the speakers at 8 ohms 
and 4 ohms. 

Summary of Contents for Cyber300BD










Reviews: